REGISTER YOUR SRT-6 HERE
CONTACT US

LATEST ENTRIES

SRT-6 VIN REGISTRY

LATEST LISTINGS

CROSSFIREMARKET

LATEST UPDATES

SRT-6 FACEBOOK

LATEST UPDATES

SRT-6 INSTAGRAM

LATEST UPDATES

SRT-6 YOUTUBE

LINKS

CLUBS & FORUMS

MESSAGES FROM

SPONSORS

SEATBELT UPGRADE

 

EASY DIY WITH STEPS TO REMOVE AND INSTALL

 

If you are in need of changing seatbelts due to wear and tear or you simply are upgrading to more sporty colored seatbelts, can be purchased on www.crossfiremarket.com [HERE], then this DIY step by step booklet will be quite helpful. Follow the instructions carefully, prepare tools and should be just fine. Please feel free to contact us or give any feedback regarding doing things differently.

 

 

  1. Move the seat to the full forward position.

 

  1. Disconnect the negative battery cable (2). Wait two minutes for the system capacitor to discharge before further service.

 

  1. Remove the plastic bolt cover from the seat.

 

  1. Remove the bolt (1) on the belt end attaching it to the seat. (tighten to 35 N·m (26 ft. lbs.) when re-installing)

 

  1. Remove the screws (1) attaching the plastic cover

(3) to the door opening.

 

  1. Remove the plastic cover (3).

 

  1. Remove the door edge guard (2).

 

  1. Remove screw and carefully lift up plastic piece. Easy accessible through trunk. NOTE: please use plastic prying tools to remove interior pieces.

 

  1. Remove the bolt (1) attaching the belt guide to the vehicle. (tighten to 35 N·m (26 ft. lbs.) when re-install).

 

  1. Fold back the carpet (1) in the upper corner area

 

  1. Disconnect the seat belt tensioner squib harness

connector (1). CAUTION: Do not pull on the squib connector

wires or pry on the connector insulator to disengage the connector from the inflator connector receptacle. Improper removal of the squib wires and their connector insulators can result in damage to the airbag circuits or connector insulators.

 

  1. Remove the bolt (1) attaching the seat belt tensioner to the vehicle. (tighten to 35 N·m (26 ft. lbs.) when re-installing.

 

  1. Remove the seat belt tensioner from the vehicle.

 

  1. RE-INSTALL: Work your way backwards in the list. Be sure to tighten bolts to 35 N·m (26 ft. lbs.). Enjoy!

 

 

DOWNLOADABLE DOCUMENTS

 

 

 

 

SOURCES

 

ADD MORE SRT-6 INFO
Seatbelt upgrade
Seatbelt upgrade
Seatbelt upgrade
Seatbelt upgrade
Seatbelt upgrade
Seatbelt upgrade

Before, the stock dull black seatbelts.

Seatbelt upgrade

After, the red sporty seatbelts that also can be found in SLS AMG and C63 AMG.

Copyright (©) 2012-2015 A&P Ltd. for www.srt-6.com. All rights reserved. This is NOT an official Daimler / Chrysler / Mercedes Benz / Street and Racing Technology website.Disclaimer: Material on www. srt-6 .com is protected and should not be misused.

Copyright | Privacy Statement | Terms of Use | Legal, safety and trademark information.